|
V/V, U/U
simultaneous receive capability
The IC-2750E is a unique dual band mobile, providing VHF/VHF, UHF/UHF
simultaneous receive capability along with VHF/UHF duplex operation.
Simple touch of a button changes the transmit band.
Independent
controls for each band
Operating two bands simultaneously is very simple with Icom's symmetric
layout with a wide LCD display showing both band settings in an easy to
read side by side format. The IC-2720H provides separate tuning, volume,
squelch knobs and function buttons the left and right side bands. Also,
listen to both bands independently through separate left and right band
audio jacks.
Dynamic Memory Scan (DMS)
With 212 memory channels, Icomfs exclusive Dynamic Memory Scan system
gives you flexibility over your scanning lists, fully customizable in 10
banks.
Wideband receiver
Keep on top of what is happening with the IC-2720H's wideband receiver.
Covering from 118-549 and 810-99MHz*,
you will be able to listen to almost any communications!
(* Receiver range differs depending on version)
HM-133, remote control microphone
The Icom exclusive "Hot keys" (F1/F2) memorize the most commonly used
transceiver settings.
DTCS and CTCSS
The IC-2720H incorporates 104×2 DTCS and 50 CTCSS tone codes along with
a tone scan function. Don't miss out on communications because of not
having the proper type of "tones"! The "pocket beep" feature gives you
an audible and visible indicator of an incoming call.
Compact, remote controller
The controller with the 3.5m (11.5') separation cable is an easy to
install two pieces configuration. This configuration offers the
flexibility of mounting the controller while placing the main unit in an
outof-the-way location without any additional cost. Microphone jacks are
mounted both on the controller and main unit of the radio!
 And more...
- 10dB RF attenuator
- Selectable squelch delay
- 9600bps packet data terminal (mini-DIN 6-pin connector)
- Optional MB-85 allows you to mount the controller to the main unit
- 14 DTMF memory channels (24 digits)
- Sub band auto mute function
- MOS-FET power amplifier
- Weather Alert
- Auto repeater function
- Wide/narrow channel spacing
|
SPECIFICATIONS
| GENERAL |
| Frequency coverage |
: Guaranteed 144 - 146, 430 -
440 MHz
Rx (Left); 118 - 549.995 MHz
(Right); 118 - 173.995, 375 - 549.995, 810 - 999.990**
MHz |
| Mode |
: FM, AM*
*Rx only; not guaranteed |
| Number of memory ch. |
: 212 (incl., 10 scan edges and
2 call Ch.) |
| Antenna connector |
: SO-239 (50 ohm) |
| Power supply requirement |
: 13.8 V DC ±15% (negative
ground) |
| Frequency stability |
: ±10 ppm -10°C to +60°C |
| Current drain |
: Tx
Rx |
VHF 50 W
UHF 35 W
Standby
Max. audio |
12 A
11 A
1.2 A
1. 8 A |
|
| Usable temp. range |
: -10°C to +60°C; |
Dimensions
(projections not included) |
: Controller; 140(W) × 50(H) ×
24.5(D) mm;
Main unit; 140(W) × 40(H) × 187(D) mm; |
| Weight |
: Controller;150 g; Main unit;
1.25 kg; |
|
| TRANSCEIVER |
Output power
(continuously adjustable) |
: VHF; 50 W, 15 W
typ., 5 W typ. selectable
UHF; 35 W, 15 W typ., 5 W typ. selectable |
| Modulation system |
: Variable reactance modulation |
| Spurious emission |
: Less than -60 dB |
| Microphone connector |
: 8-pin modular (600 ohm) |
|
| RECEIVER
|
| Receive system |
: Double-conversion superheterodyne
system |
| Intermediate
frequencies |
: 1st 38.85/46.05 MHz
2nd 450/455 kHz |
| Receive
Sensitivity (at 12dB SINAD) |
: Less than 0.18 µV |
| Selectivity |
| : More than 12/6kHz
at -6dB/Less than 30/20 kHz at -60 dB |
|
Spurious and image
rejection ratio |
|
| Audio output power (at 13.8 V
DC) |
: More than 2.4 W
at 10% distortion with an 8 ohm |
| Ext SP connector |
: 2-connector 3.5 (d) mm |
Supplied accessories:
- Hand microphone, HM-133
- DC power cable, OPC-1132
- Mounting bracket, MB-84
- 3.5 m separation cable
- Spare fuse
All stated specifications are subject to change without notice or
obligation.
OPTIONS
- HM-118N Regular HAND MICROPHONE
- HM-118TN DTMF microphones with keypad backlighting.
- HM-133 HAND MICROPHONE
Remote control microphone with keypad backlighting. Same as supplied.
- CS-2720 + OPC-478/OPC-478U CLONING SOFTWARE + CLONING CABLE
For quick and easy programming of memories, etc.
OPC-478: RS-232C cable; OPC-478U: USB cable
- SP-7/SP-10 EXTERNAL SPEAKER
- OPC-440/OPC-647 MIC EXTENSION CABLES / OPC-440: 5.0 m; OPC-647:
2.5 m
- OPC-589 MIC ADAPTER CABLE / Allows you to connect an 8-pin
microphone.
- OPC-441 SPEAKER EXTENSION CABLE / 5.0m) of extension cable for
speaker.
- OPC-347/OPC-1132 DC POWER CABLES / OPC-347: 7.0m; OPC-1132:
3.0m
- OPC-1155 SEPARATION CABLE / remotely install the transceiver.
(3.5m)
- OPC-1156 CONTROLLER EXTENSION CABLE / Extension cable for
OPC-1155, A modular connector is supplied.
- MB-84 CONTROLLER BRACKET
Mounts the remote controller in a convenient location for operation with
the controller detached.
- MB-85 COMBINATION BRACKET
Mounts the remote controller to the main unit. 20cm separation cable is
supplied.
- MB-65/120 MOUNTING BASE / Mounts the remote controller with the
MB-84. Adjustable angle and direction for optimum positioning.
- MB-17A MOBILE MOUNTING BRACKET / The main unit is easily
attached and removed.
 |
 |
 |
 |
 |
|
HM-118N |
HM-118TN |
HM-133 |
SP-7 |
SP-10 |
 |
 |
 |
 |
 |
|
OPC-440 |
OPC-441 |
OPC-589 |
OPC-347 |
Gear
Keeper |
 |
 |
 |
 |
 |
|
OPC-1156 |
MB-84 |
MB-85 |
MB-65/120 |
MB-17A |
|
|
|
